Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1616004.png)
ATTENTION:
Increased risk of accidents when lowering in the front axle carrier.
^
Material damage and injury (e.g., crushing) can occur caused by improper work.
^
Wear protective gear, e.g. gloves.
^
Position the mounting frame in the correct position on the lifting platform. Pull out front axle carrier carefully.
^
Watch out for falling parts during removal on the mounting frame.
Note:
^
These removal and installation instructions apply to vehicles with level adjustment and steel springs. The points relating to level adjustment are not
relevant for vehicles with steel springs.
1. Open the engine compartment lid and secure with the bonnet stay 97040.
2. Remove engine design covers.
Note:
^
Point 3 is not necessary for a 6-cylinder engine. There is a perforated plate at both the front right and rear left of the engine for transporting and
raising to the safety device.
3. Remove -torque support- from the engine. Then -arrow- re-insert fastening screw arrow.
4. Position the safety device 10-222 A correctly and fit the chain to the fastening bracket -A-. Fit the transport eyebolt 97000 for securing the engine
-B- (the bore for the transport eyebolt is located between cylinder 6 and 7 on the left cylinder bank).
