Removing and Installing Momentary-Switch Handle For Spare Wheel Mount
/v6-3.2l/Page-1694006.png)
2. Unclip cover -1-.
3. Undo fastening screws -2-.
4. Remove threaded plate -3-, holder -4- and bellows -5-.
Installing holder
1. Position bellows -5-, holder -4- and threaded plate -3-.
2. Hand tighten fastening screws -2-.
3. Swivel the spare wheel mount with spare wheel mounted to the vehicle and engage in lock. If necessary, adjust the setting of the holder.
4. Move holder -4- until it engages correctly in the lock.
5. Tighten fastening screws -2- to the correct tightening torque. -Tightening Torque: 24 ft lb. ± 2 ft lb.
6. Clip in cover -1-.
