Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-476005.png)
1. Use a suitable tool to grip and release the chain tensioner to the right and side of the top chain case lid.-arrow-
2. Remove chain tensioner with sealing ring. Replace sealing ring.
Installing chain tensioner
ATTENTION Engine damage can occur if the chain jumps over!
^
Never turn the engine on the crankshaft without a chain tensioner.
^
Make sure that nobody starts the engine or pushes the vehicle while in gear when the chain tensioner is removed.
^
Stick a warning note on the steering wheel or ignition lock.
Note: Replace sealing ring on chain tensioner.
1. Screw in chain tensioner with new sealing ring.
2. Tighten chain tensioner. Tightening torque: 30 ft-lb.
3. Remove protective covers.
Subsequent work
1. Fit engine compartment cover at center and rear.
2. Re-install design cover.
