Cayenne (9PA) V6-3.2L (2006)
Installing top chain case lid
ATTENTION Leaks due to components being at too low a temperature or at different temperatures!
^
If components that are cold or at different temperatures are sealed together by the application of sealant, adhesion problems and leaks
can arise due to the build-up of condensation water or component distortion.
^
Components must have reached at least 17°C throughout.
^
Components must not be too hot (distortion).
^
Spare parts that are stored in the cold or heat (strong sunlight), must be brought to room temperature or the same temperature as other
parts before installation.
Note: If both chain case lids were removed, install the bottom one first.
1. Check all sealing rings and replace if necessary.
2. Check sealing rings for the hydraulic valves of the camshaft adjusters and replace if necessary.
3. Prepare cylinder head gasket for installation of the chain case lid. To do this, apply silicone sealant 000.043.300.39 to the corners of the cylinder
head gasket and cylinder head. Fill the bores of the cylinder head gasket with sealant -arrows-.
4. Apply a thin coat of sealant 000.043.300.39 evenly to the sealing faces (don't forget the contact surfaces for the cylinder head gasket). Mount
chain case lid immediately and position fastening screws.