Cayenne (9PA) V6-3.2L (2006)
15. Close off the connections and lines immediately using suitable plugs -b and c-, then move the lines out of the work area.
16. Release connector (for reasons of accessibility) using a suitable tool -d--arrow A- and pull it off -arrow B-.
17. Unscrew fastening screws -arrows 4 and 5- and take out the air-conditioning compressor by pulling it to the side and upwards -arrow-.
Installing air-conditioning compressor
ATTENTION:
Risk of damaging the air-conditioning compressor.
-
The engine must not be started until the air-conditioning system has been filled.
NOTE:
-
If the air conditioning compressor is blocked/seized up, then additional steps must be carried out to ensure the operation of the air conditioning.
-
New compressors are pressurised and are filled with the required amount of oil for the refrigerant circuit.
-
The remaining oil quantity in the individual components must therefore be taken into account.
-
Refrigerant oil from the compressor or refrigerant oil removed by suction from a previously run air-conditioning system may no longer be used
(special-category waste).
1. First, open the plugs on the high-pressure side and relieve the pressure from the compressor -b-.