Cayenne (9PA) V6-3.2L (2006)
Headlamp Control Module: Service and Repair
Removing And Installing Control Unit For Gas Discharge Lamp
Preliminary work
1. Switch off light. Remove main headlight.
Removing control unit for gas discharge lamp
WARNING:
Risk of short circuit.
-
Before removing fog light, remove ignition key and switch off light switch.
NOTE:
-
The control unit is located underneath the Bi-Xenon headlight.
-
The control unit also has the task of driving the motors for the headlight beam adjustment (HBA) of the Bi-Xenon headlight.
1. Open the two locking clips -1- and remove cover -2-.
2. Turn the headlight over and set down on a suitable base.
3. Remove all six fastening screws -3- and pivot up the control unit.
WARNING:
Risk of damage to the control unit for the gas discharge lamp.
-
It is essential to pull connectors 4 and 5 straight out.
4. First actuate latch of connector -5- and remove the connector. Open clip of connector -4- and pull out the connector.