Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1768002.png)
5. Remove seal -A- from headlight.
Installing control unit for gas discharge lamp
WARNING:
-
Risk of short circuit.
-
Before removing fog light, remove ignition key and switch off light switch.
-
Risk of damage to the control unit for the gas discharge lamp.
-
It is essential to push plugs -4- and -5- in straight.
NOTE:
-
The control unit is located underneath the Bi-Xenon headlight.
-
The control unit also has the task of driving the motors for the headlight beam adjustment (HBA) of the Bi-Xenon headlight.
-
Ensure that the seal -A- is properly positioned on the control unit.
1. Insert connector -4- and secure with locking clip. Push in connector -5- until it engages.
2. Position control unit and secure with the six fastening screws, starting in the centre. Tightening torque: 2 ftlb.
