Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1422003.png)
Removing sensor on wheel housing
ATTENTION:
Danger of injury and damage to property as a result of incorrect handling of airbag sensors.
-
Risk of confusing the front, middle and rear sensors, since they do not differ in appearance.
-
Always observe the safety regulations for handling airbag units
-
Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is avoided.
-
Before the connector is disconnected from the sensor, always wait for 1 minute before disconnecting the battery.
1. Push in lock -2- on plug for sensor -1-, until this perceptibly engages -arrow A-.
2. Release locking mechanism on the latch -2--arrow B- and pull off plug from sensor -1--arrow C-.
3. Unscrew the two fastening screws -4- and remove the sensor.
Installing airbag sensor
Installing sensor on lock support
WARNING:
Danger of injury caused by loose, safety-related bolts.
-
Always replace fastening screws of the sensors after customer service and reworking.
-
Never make alterations to the micro-encapsulated screws, which have a negative effect on the bond (e.g. using lubricant, loosening bolts
