Cayenne (9PA) V6-3.2L (2006)
5. Press the electric connector together -arrow a- and pull it off.
Installing front angle sensor for headlight beam adjustment
NOTE: If a new angle sensor has been installed for headlight beam adjustment (HBA), the headlights must be recalibrated using the Porsche System
Tester.
1. Push electric plug onto angle sensor until the connector is felt to engage.
2. Engage angle sensor lever and position angle sensor.
3. Tighten the fastening screws -3-. Tightening torque: 3.25 ftlb.
4. Position the fastening nuts -2-, counter with an open-ended wrench on the two flats -1- and tighten the nuts. Tightening torque: 6 ftlb.
Calibrating angle sensor for headlight beam adjustment
NOTE:
-
The angle sensors are installed together with the Bi-XENON headlights and the steel-spring running gear.
-
An angle sensor is located at the front left and rear left in running gears with steel springs.
-
The level sensor is screwed to the bearing block and upper control arm.