porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Removing and Installing Cut-Off Relay|Page 5463 > < Removing and Installing Cut-Off Relay|Page 5461
Page 7
background image

8. Close the cover -arrow B-, until the lugs -arrows C- are felt to engage.
9. Position battery ground strap on the body and screw it on tight with the fastening nut -arrow 2-. Tightening torque: 3.5 ftlb.

10. Move the seat in its folded position towards the rear -arrow A-and then tip forward -arrow B-.

11. Screw in fastening screws -arrows 1-. Tightening torque: 33 ftlb.
12. Clip in front seat trim -arrow C-.

Checking cutoff relay operation

1. Connect and switch on the Porsche System Tester.
2. Switch on ignition.
3. Establish communication with the airbag control unit.
4. Read out fault memory: No fault stored.

Removing and Installing Cut-Off Relay|Page 5463 > < Removing and Installing Cut-Off Relay|Page 5461