Cayenne (9PA) V6-3.2L (2006)
ATTENTION:
Risk of material damage to screw connections for seat and seat frame.
-
The fastening screws for seat and seat frame are coated and must be replaced after being unscrewed.
-
Before screwing in the new fastening screws, clean the thread holes with an M10 x 1.5 tap.
23. Place rear seat support in installation position -Arrow A- and tighten with fastening screws -5-.Tightening torque: 37 ftlb..
24. Attach line to threaded bolt -Arrow B- and secure with clip-Arrow C-.
25. Push connector into clip -Arrow D- until locking tab -E- is felt to engage.
26. Fasten line with new tie-wraps -F-.
NOTE: Tighten the tie-wraps so that the auxiliary battery line can just still be moved with the cover installed.
27. Fasten cover with new tie-wraps -A- to both lines (spare wheel well) and fit the cover on the threaded bolts -Arrow B-.