Cayenne (9PA) V6-3.2L (2006)
9. Fasten air intake housing from the inside with the holders -Arrow B-.
10. Place support for DME control module in installation position -Arrow A- and screw down with fastening screw -2- and fastening nuts -3-.
Tightening torque: 6 ftlb.. Tightening torque: 6 ftlb..
11. Place line in installation position -Arrow B- and close clip -Arrow C- until locking tabs are felt to engage.
12. Place lines with twist locks (to rear of DME control unit) -a- on the threaded bolts -arrow- and tighten with fastening nuts -1-. Tightening torque:
6.5 ftlb..
13. Install DME control module.
14. Install plenum panel at front right.
15. Connect plug connection (right of DME control module) -Arrows A- until locking tab -B- is felt to engage.