Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1151010.png)
WARNING:
Risk of accident due to triggering of the airbag (malfunction in the airbag system) caused by improper work on airbag components
cannot be ruled out.
^
In the case of such a malfunction, an unsuitable steering-wheel holder could cause injury or damage.
^
Use only steering wheel holders which do not project into the area of the airbag unit.
^
Observe safety regulations when working on vehicles with airbags!
7. Clamp steering wheel in center position with steering wheel holder.
Note:
^
Use only steering wheel holders that do not project into the area of the airbag unit!
^
If necessary, shorten guide rod at top!
8. Adjust toe at hexagon of tie rod(s) after releasing lock nut(s). The steering angle sensor must subsequently be calibrated by PSM.
WARNING:
Risk due to malfunction in PSM control range if steering angle sensor is uncalibrated or incorrectly calibrated.
^
Injury and material damage possible.
^
Calibrate steering angle sensor with wheels in straight-ahead position using the Porsche System Tester.
^
The steering angle sensor actual value must be checked after a suspension alignment where no changes have been made to the wheel alignment
values.
Specified tightening torque of fastening nut(s) (lock nut) -C- = 70 Nm (52 ft lb.)
Front-axle toe-difference angle
