Cayenne (9PA) V6-3.2L (2006)
Ride Height Sensor: Service and Repair
Replacing Front Level Sensor
Replacing front level sensor
Removing front level sensor
Note:
^
In running gear with level adjustment, a self-levelling sensor is installed on each spring strut.
^
Removal and installation is described for the right spring strut.
^
The self-levelling sensor is screwed to the bearing block and upper control arm.
Turn steering until access to the self-levelling sensor is achieved.
1. Counter with an open-ended wrench on the two flats -1- and unscrew the fastening nuts -2-.
2. Unscrew both fastening screws -3-.
3. Disengage lever from self-levelling sensor, swivel it forwards and remove the sensor.
4. Press the electric connector together -a- and pull it off.
Installing front level sensor
Note:
^
In running gear with level adjustment, a self-levelling sensor is installed on each spring strut.
^
Removal and installation is described for the right spring strut.
^
The self-levelling sensor is screwed to the bearing block and upper control arm.
1. Press the electric connector onto the self-levelling sensor until it clicks into place.