Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1239006.png)
^
The three rubber-metal mounts -A,B,C- must be replaced once the trailing arm is removed.
The pressure pieces and the tubular piston cylinder VAS 6178 are used for removal. This involves screwing pressure head T10205/13 into the tubular
piston cylinder. T10230/2 is screwed on to the threaded rod and positioned in T10205/13 for pressing bearings in and out. Nut T10230/15 and washer
T10230/14 are screwed onto the opposite end of the threaded rod.
The following pressure pieces and nuts are required for bearings -A-:
Pressing out Tools for pressing out hydraulic/rubber-metal mounts
^
T10230/2
^
T10230/7
^
T10230/9
^
T10230/10
^
T10230/14
^
T10230/15
Note:
When using the pressure pieces, the direction arrow shows the direction for pressing the rubber-metal mounts in or out on the trailing arm.
The pressure pieces are used as follows
^
Arrangement of tools for pressing out hydraulic/rubber-metal mounts.
