Cayenne (9PA) V6-3.2L (2006)
These removal and installation instructions apply to vehicles with level adjustment and steel springs. The points relating to level adjustment are not
relevant for vehicles with steel springs.
ATTENTION:
Increased risk of accident when working on the exhaust system, the rear axle and the vibration dampers.
^
Possible danger of injury or damage.
^
Wear protective gear, e.g. gloves.
^
Position the mounting frame correctly on the lifting platform and carefully remove the rear axle housing.
^
Watch out for falling parts during removal on the mounting frame.
1. Remove the combination wires at the joint (brake wear, CDC sensor) -1- and then unclip the rubber sleeves -2- from the sheetmetal holders.
2. Undo the brake caliper and hang it in a suitable place in the wheel housing.
Note:
^
Always wear safety goggles and gloves when working on vehicles with level adjustment.
^
Mark the installation position (e.g. with a felt-tip pen) when removing the cardan shaft.
^
Mark the installation position (e.g. with a felt-tip pen) when removing the rear axle housing.