Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1273016.png)
9. Fit the tie rod ends. The tightening torque for the fastening nut for attaching the tie rod end is 70 Nm (52 ft lb.).
10. Fit the engine guard and the front wheels.
11. Remove the safety device 10-222 A. To do this, remove the transport eyebolt 97000 -B- and the chain -A-, which is used to secure the engine.
12. Fit the -torque support-.
13. Bleed power-assisted steering.
14. Fit engine design covers and radiator tank cover.
Installing front-axle carrier - V6
ATTENTION:
Increased risk of accidents when running in the front axle carrier.
^
Material damage and injury can occur.
^
Material damage and injury if the wheel carrier is raised improperly.
^
Position the mounting frame correctly on the lifting platform and carefully install the front axle carrier.
^
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a
suitable intermediate layer (hard rubber).
^
Do not damage the brake cover plate.
^
Watch out for falling parts during installation on the mounting frame.
^
The steering angle sensor must be calibrated following repairs.
Note:
^
Before installing, give the parts a visual check.
^
Note previously applied markings on the front axle carrier and on the cardan shaft.
^
A second worker is required in order to avoid damaging adjacent components when fitting the front axle carrier.
^
When fitting the ball joints, ensure that the bevel pinions are clean! Remove dirt or grease on bevel pinions, e.g. with a lint-free cloth. Do not use
cleaning agent/solvent.
^
Replace all fastening nuts and all expansion screws (screws which are fitted with torque angle tightening procedure).
