Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1278015.png)
7. Grease mounting-face ring of axle nut with a little Optimoly TA aluminum paste. Screw on axle nut to prevent the shaft from slipping out. If the
shaft cannot be pushed right in, use assembly fixture T10206 to pull the drive shaft in. Remove protective tube (shop made) 00000 and base.
8. Fit drive shaft to the transmission flange and tighten brake caliper fastening screw.
9. Mount connecting link.
10. Connect compact connector in wheel housing -arrow-. Mount support for brake hose/combination line on top of wheel carrier. Connect sensor
connectors.
Note: Observe torque on residual pressure retaining valve.
11. Fit pressure line at residual pressure retaining valve -(arrow)- using insert part T10212. Note tightening torque.
