Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1304007.png)
1. Place the cap -1-, rubber stop -2- and protective sleeve -3- together as follows before pushing them on to the piston rod:
^
Push the rubber stop -2- up fully into the protective sleeve -3-.
^
Slide the cap into the protective sleeve -see figure- and pull the lip carefully over the cap.
2. Place the bottom concave washer (grey) -see figure- together with the bottom support -see figure- at the correct position (not twisted).
At the correct position means that the two individual parts are fitted precisely together.
