porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Vehicle Lifting|Service and Repair|Page 6696 > < Axle Nut|Specifications
Page 1
background image

Vehicle Lifting: Service and Repair

Lifting the vehicle
Preliminary work
Raising the vehicle

DANGER: 
Risk of injury due to vehicles slipping or tilting off lifting platforms.
^

Risk of injury due to vehicles slipping or tilting off lifting platforms may be caused by improper alignment of the lifting platform arms or
support plates, and by raising, supporting or removing units on raised vehicles.

^

Align the vehicle evenly between the lifting platform columns.

^

Lift the vehicle only at the take-up points provided.

^

Check that the support plates are seated correctly by raising the vehicle slightly and performing a visual inspection.

^

In order to ensure that the vehicle is not lifted off the support plates during assembly work, the vehicle must be secured on the lifting
platform, or the shift in the center of gravity must be offset by a corresponding load in the vehicle, when units are removed or supported.

^

In addition, the guidelines of the lifting platform manufacturers and the legal accident prevention regulations and those of the mutual
indemnity association (VGB 14) must be observed.

ATTENTION: 
Danger of material damage if the vehicle is raised incorrectly.
^

Lifting or supporting the vehicle at unsuitable take-up points can lead to material damage on the vehicle.

^

Raising the vehicle in the sill area will lead to the deformation of body parts and to leakage in the underbody area.

^

Lift the vehicle only at the approved take-up points.

When driving into the platform lift, pay attention to work to be carried out. i.e. if work has to be carried out in the front footwell, the vehicle should be
positioned in such a way that the front doors can be opened far enough.
If the vehicle is a Cayenne with air suspension/level control, observe the following instructions.

Adjusting car to normal level

If air suspension accumulators of the air suspension are filled, only the ignition has to be switched on. If air pressure in accumulators is too low,
compressor comes on and loads battery. In this case, a constanter (charging unit) must be connected or the engine must be started.
Stop the vehicle and apply the brake.
Close vehicle doors.
Tap the right-hand rocker switch on the center console in the appropriate direction until vehicle has reached normal level. The middle indicator light
next to the rocker switch is permanently on. If a further indicator light should come on, a different level is adjusted.

Switching off level control

To do this:
^

Adjust car to normal level.

^

Switch on ignition.

^

Push --> time value: 5 s + 5 s forwards.

The message Control switched off appears in the variable control display of the instrument panel.

Switch on level control

To do this:
^

Switch on ignition.

^

Push --> time value: 5 s + 5 s forwards, or

^

set off with the vehicle. Level control comes on automatically.

Vehicle Lifting|Service and Repair|Page 6696 > < Axle Nut|Specifications