Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-855001.png)
Valve Body: Procedures
Removing and installing electro hydraulic control unit
Preliminary work for electro hydraulic control mechanism
1. Remove pipe set in transmission.
Removing the electro hydraulic control unit
Control unit fastening screws
1. Remove electro hydraulic control unit. To do this, unscrew fastening screws -arrows- and remove the control unit.
Installing the electro hydraulic control unit
Control unit fastening screws
Note: Screws which are tightened with a torque angle must be replaced with new ones.
Note: The adaptation values of the Tiptronic control unit must be reset using the Porsche System Tester when replacingchanging the electro hydraulic
control unit.
1. Install electro hydraulic control unit. To do this, screw in new fastening screws -Pfeil-. Initial tightening 6 ft. lbs. Final tightening 90° angle
