Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-858006.png)
Note:
^
The adaptation values of the Tiptronic control unit must be reset using the Porsche System Tester when replacing/renewing the wire harness.
1. Install output shaft speed inductive pickup. To do this, screw in fastening screw -arrow-. Tightening torque: 7.5 ftlb.
Note:
^
Screws which are tightened with a torque angle must be replaced with new ones.
2. Install electrohydraulic control unit and screw in new fastening screws -arrows-. Initial tightening: 6 ftlb. Final tightening: 90 Winkel-Grad
3. Plug in cable plug -2- for output shaft speed inductive pickup. -arrow-
4. Install wire set for sensors through opening in the housing.
