Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-880007.png)
Note: Noises in drive line
^
Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing
^
Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing
Note: Noises in drive line
^
Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing
^
Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing
1. Mark centre of bulge in rubber mounting ->Marking for centre of rubber mounting.
2. Position special tool assembly fixture 9716 a/b on rubber mounting.
Installing rubber mounting
3. Pull in rubber mounting until installation position is reached.
