Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-895012.png)
Joint on transmission side: regrease as required, depending on the amount of grease left in the joint. Before replacing the cap, fill in the required
amount of grease.
Joint pin on wheel side: regrease as required, depending on the amount of grease left in the joint. The joint pin is supplied ex-works with
approximately 80 grams of grease at the outside and approximately 40 grams at the inside.
Remove excess grease with a lint-free cloth. Push the required amount of grease through the joint to the outside. Then grease the inside of the
joint.
3. Fit the large hose clamps for the two boots. The hose clamp lug - on the transmission side - must be positioned between two bores on the joint.
4. Fit the small hose clamps for the two boots between the grooves. If the boots are fitted correctly, the groove -A- will be visible.
