Cayenne S (9PA) V8-4.8L (2010)
1.2 Position roof rail cross bars (-> Instructions for using roof rail cross bars and labor operation no. 669223).
1. 2. 1
Loosen front cross bar if necessary and fit loosely in the B-pillar area leaving gap A (-> Figure 4 -A-) with respect to the seam in the
roof rails. Gap A ~ 2.5 cm
1. 2. 2
Loosen rear cross bar if necessary and fit loosely in the C-pillar area leaving gap B (-> Figure 4 -B-) with respect to the seam in the
roof rails. Gap B ~ 15.0 cm
1. 2. 3
Check gap X (-> Figure 4 -X-) between the brackets. Gap X ~ 80 cm
1. 2. 4
Bolt both cross bars securely to the roof rails.
1. 2. 5
Decide which side (driver's or passenger's side) you want to fit the roof box on and close the caps on the opposite side.
1.3 Prepare roof box for mounting
INFORMATION: When opening, make sure that the opposite lock is locked.
1. 3. 1
Unpack the roof box and unlock it with one of the keys supplied. Turn the key clockwise to do this.
1. 3. 2
Move all four perforated strips (-> Figure 5 -1-) into the guides ( -> Figure 5 -2-) so that the centre slot ( -> Figure 5 -3-) is centered
in the cut-out on the guide.
1. 3. 3
Check that the rubber seal ( -> Figure 5 -4-) is seated and positioned correctly on the underside of the clamp (-> Figure 5 -5-) and
adjust it if necessary.
1. 3. 4
Insert an M8 T-bolt ( -> Figure 5 -6-) into the center slot from below and fit a clamp ( -> Figure 5 -5-) onto the thread.
1. 3. 5
Loosely fit M8 butterfly nut ( -> Figure 5 -7-).