Cayenne S (9PA) V8-4.8L (2010)
/v8-4.8l/Page-83001.png)
Steering Wheel: Service and Repair
Removing and installing steering wheel
Preliminary work
1. Disconnect battery.
2. Remove steering wheel airbag unit.
Removing steering wheel
Caution:
Increased risk when handling airbag modules.
^
Injury and material damage may occur if airbag units are not handled correctly".
-> Observe safety regulations for handling airbag modules.
1. Turn wheels to straight-ahead position. Before removing steering wheel, make a colored mark on steering wheel and steering column (centering of
airbag spiral spring).
Information:
^
Disconnect steering wheel heating if fitted on vehicle.
2. Remove steering wheel by releasing multiple-tooth screw.
Installing steering wheel
Information:
^
The steering wheel is made of magnesium alloy! The tightening torques must be strictly observed!
^
Wheels straight ahead and observe previously applied markings!
^
Airbag unit must lock with an audible click! Check by pulling at airbag unit!
^
Always replace the multiple-tooth screw!
^
Observe tightening torque.
Installation of the steering wheel takes place in reverse order.
Subsequent work
1. Install steering wheel airbag unit.
2. Connect battery.
