Cayenne Titanium (9PA) V8-4.5L (2006)
These removal and installation instructions apply to vehicles with level adjustment and steel springs. The points relating to level adjustment are not
relevant for vehicles with steel springs.
Caution:
Increased risk of accident when working on the exhaust system, the rear axle and the vibration dampers.
^
Possible danger of injury or damage.
-> Wear protective gear, e.g. gloves.
-> Position the mounting frame correctly on the lifting platform and carefully remove the rear axle housing.
-> Watch out for falling parts during removal on the mounting frame.
1. Remove the combination wires at the joint (brake wear, CDC sensor) -1- and then unclip the rubber sleeves -2- from the sheet metal holders.
2. Undo the brake caliper and hang it in a suitable place in the wheel housing.
Information:
^
Always wear safety goggles and gloves when working on vehicles with level adjustment.
^
Mark the installation position (e.g. with a felt-tip pen) when removing the cardan shaft.
^
Mark the installation position (e.g. with a felt-tip pen) when removing the rear axle housing.
^
The take-up points 11 and 22 are required for removing the rear axle. Remove the remaining take-up points.
3. In vehicles with level adjustment, disconnect the air connection to the spring struts -arrow- (front axle connection shown here).