Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1090002.png)
4. Remove disc brake pads.
Installing
Installing front disc brake pads
Warning:
Danger of accidents if old parts are fitted on brake caliper.
Fit new expanding spring, new retaining pin and new retaining pin screw on the brake caliper.
Warning:
Danger of accidents if brake pads of the wrong quality are installed.
Use only the type-specific brake pads listed in the Porsche Spare Parts Catalogue.
Do not grease the back of the disc brake pad!
The new disc brakes must be clean and free of grease!
Check disc brakes for wear.
The core of the warning contact line must not be left exposed! It does not matter if the insulation is worn!
Use a new repair kit!
Observe tightening torques.
1. If necessary, push brake piston back into its original position using the piston resetting fixture (replaces P83) NR.144.
2. Fit new disc brake pads.
Information:
Make sure that the retaining pin is inserted in the correct position! The flat side surfaces prevent the retaining pin from twisting in the brake caliper
.
3. Install expanding spring. Center the retaining pin in the bore with the M8 auxiliary screw. To do so, press retaining pin back with auxiliary screw
and push retaining pin through. Remove auxiliary screw and fit fastening screw at retaining pin with specified tightening torque!
