Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1096002.png)
5. Undo brake caliper on wheel carrier and hang it in a suitable place in the wheel well (do not open brake hydraulics!). But first pull out the electric
lines from the holder on the brake caliper and the brake pad wear line from the holder on the wheel carrier.
6. Remove brake disc after unscrewing the fastening screw. If necessary, remove the brake disc by tapping it gently with a rubber hammer.
Installing rear brake disc
Do not confuse right and left brake discs during assembly!
Distinguishing characteristic: Part No.! The flat surface of the brake discs is marked with R = right or L = left.
1. Check that all parts are in perfect condition and replace them if necessary.
2. Clean the levelling and centering surfaces on the brake disc and wheel hub. Then apply a very thin coat of Optimoly TA to the centering surface on
the wheel hub.
3. Fit the brake disc. Observe tightening torque.
4. Adjust the brake shoes of the foot-operated parking brake with a screwdriver.
5. Fit the brake caliper. Replace the brake caliper fastening screws following removal. Observe tightening torque.
6. Position disc brake pads by operating the brake several times.
7. Check brake fluid level and correct it if necessary. The brake fluid level must be within the MIN/MAX marking.
