Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1108011.png)
Information:
On vehicles whose cables are still good but stretched, the -3- ring grooves of the circlip can be used as compensation.
In this case, loosen the circlip carefully (do not remove from brake cable!) and move by one ring groove. The circlip and cable are only available
as an assembly. The settings should be the same on both sides.
If the circlip has been damaged during removal/fitting (e.g. bent out of shape, circlip bent up), the entire cable must be replaced.
Use new sheetmetal clips. Pay attention to the installation position.
1. Insert the end of the cable with the hexagon into the Quickfit on the wheel bearing housing. Push the cable at the other end (ball head) towards the
wheel bearing housing until the hexagon engages audibly in the Quickfit. Ensure a good seal.
2. Look through the brake disc opening with a small lamp to check that the end of the cable (hexagon) is seated correctly in the Quickfit.
3. Make sure that the circlip is seated correctly -arrow-. (Shown here on the removed cable.)
