Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1121002.png)
Pressure sensor
1. Remove the pressure sensor.
1.1.
Carefully clamp the brake master cylinder in a vice using aluminum jaws.
1.2.
Remove the pressure sensor -1-.
2. Install the pressure sensor.
Fit the new pressure sensor -1- and tighten to the prescribed tightening torque.
Subsequent work
1. Install the brake master cylinder.
2. Install trim panels in the engine compartment.
3. Install wiper arms at the left and right.
4. Bleed the hydraulic system.
Brake fluid reservoir
Do not top up the brake fluid level above the -MAX- marking after bleeding the system.
