Cayenne Titanium (9PA) V8-4.5L (2006)
Loosening the coolant pump with a plastic hammer
Installing coolant pump
Installing coolant pump
Notice:
Incorrect handling of pulley
Risk of damage to pulley
-
The pulley is sensitive to impact. Do not prise off the pulley with a screwdriver.
-
Do not re-use a damaged pulley.
1. Clean sealing surfaces. Mount new sheetmetal seal on the coolant pump. Slide the new sheetmetal seal over the dowel pins.
New sheetmetal seal on the coolant pump
2. Tighten the eight fastening screws. - Tightening torque: 10 Nm (7.5 ftlb.) Mount the sheetmetal holder for the cable duct using the two upper
fastening screws.
Mount the fastening screws for the coolant pump