Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-443008.png)
ATTENTION Danger of crushing!
^
Risk of crushing your hands when lifting the crankshaft.
^
Hold the very outside of the crankshaft.
^
Wear gloves.
3. Insert crankshaft. The connection flange must point towards the back of the engine. Then secure the crankshaft from falling down using holding
bridges 9677. Fix the holding bridges at bearing locations 3 and 5. Screw the fastening screw from the belt pulley at the front into the crankshaft
and tighten slightly so that the crankshaft can be turned -see figure-.
4. Turn crankcase by 180° on the assembly support.
5. Install pistons.
6. Turn crankcase again through 180° on the assembly support.
7. Make sure the crankcase is ready to be screwed in. Check that the sickle discs are positioned correctly. Degrease parting surfaces between top and
bottom section of crankcase. A totally grease-free product (e.g. brake cleaner) must be used for this. Then insert a new O-ring at the front of the
parting surface -3-.
