Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-444007.png)
Centering pins
9. Insert bearing shells into lower part of crankcase and lightly oil them. When doing so, ensure that the twist locks (retaining lugs) fit into the
appropriate recesses in the lower part of the crankcase.
Twist locks (retaining lugs)
Information:
The liquid sealant must be applied and the screws screwed in within five minutes at most and without interruption.
The required tool (torque wrench for 15 Nm (11 ftlb.) to 40 Nm (30 ftlb.); torque angle wrench; socket wrench E12, E14 and E14) must be ready
for use.
The threads and head contact surface of the bearing seat screws (M10 x 1.5 and M12 x 1.5) must be oiled.
10. Apply Drei Bond Silikon 2210 liquid sealant (000.043.204.58, status 02/06) to the lower part of the crankcase as shown. The outer surfaces
marked -A- must be cleaned after fitting.
Applying sealant
11. Place lower part of crankcase into position. When doing so, make sure that the sealing bead is not destroyed.
Information:
Unscrew the centering pins again while securing the lower part of the crankcase.
