Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-448002.png)
-
The engine must be supported at the oil pan or engine carrier using suitable lifting equipment and a wide wooden block. This applies to all engines
and assembly mountings.
Supporting engine (illustration shows V8 engine supported on the assembly support)
Preliminary work
Preliminary work for removing crankshaft pulley
1. Loosen lock carrier.
2. Loosen drive belt and remove from the pulley.
Removing crankshaft belt pulley
Removing crankshaft pulley
1. Position arm bracket 96790 in the pulley and turn it until it locks.
Arm bracket in the pulley
Caution:
Material damage!
If the tool slips or if the tool is faulty, the wings or the cooling fan can be damaged as a result of excessive forces!
-
Only use an appropriately strong tool (e.g. 3/4 inch)
-
Ensuring that the tool is seated correctly
-
Never use the special wrench socket wrench insert 9714, for loosening or tightening
-
Working with a second worker
2. Position a large torque wrench and loosen the central screw. Do not use the screw again.
