Cayenne Titanium (9PA) V8-4.5L (2006)
Installing tail light
NOTE: As of January 2003, a second generation tail light is in use. When spare parts are needed, only the second generation tail light will be supplied.
The tail light can be installed in older vehicles. During installation, the lead must be routed at the centre-of-vehicle side.
1. Push the plug connection -4- together until the connector is felt to engage.
NOTE: Check condition of clip nuts on tail lights and check fastening screws; replace if necessary.
2. Ensure that the clip nut -5- is not damaged (replace if necessary) and is inserted correctly in the vehicle body mounting point.
3. Press the ball head at the tail light -3- into the clip nut -5- and insert the tail light into the body -arrow-.
4. Screw in fastening screws -2- and press in caps -1-.
Additional assembly instructions for installing tail light
NOTE:
-
As a result of damage to the rear side section or replacement of the tail light, for example, it may be necessary to align the tail light due to an
unacceptable gap dimension (body to tail light). In this case, an adjustable lamp bracket must be installed.