Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1215006.png)
system -2-.
17. Push shrink-fit hose -4- onto the new line -1-.
18. Crimp crimping sleeve -3- using the hand crimping pliers from the repair kit for harnesses NR.155-1 to the new line -1-. Check the crimp
connection carefully.
19. Slide the shrink-fit hose -4- over the crimp connection and carefully shrink it using the hot-air blower with special nozzle (recommended
accessories for the repair kit for harnesses) so that it is watertight.
20. Slide the new line -1- into the Porsche Stability Management control unit connector until the contact is felt to engage.
21. Slide the new ground straps -1- from the repair kit into the Porsche Stability Management control unit connector until the contacts are felt to
engage.
22. Close secondary locking on the Porsche Stability Management control unit connector.
23. Tie together the wire harness with insulating tape and route it so that the crimps -1- can be positioned on the firewall in the area above the foam
grommet -2- in stages.
