Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-3004.png)
-
During coding, it is essential to guarantee the power supply for the PIWIS tester. It is essential to connect a battery charger with a current rating of
at least 40 A to the vehicle battery.
-
The PIWIS tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations may
occur with later software versions.
-
The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS tester.
1. Connect the PIWIS tester 9718 to the vehicle and start it. Switch on the ignition. >> Continue.
2. Select vehicle type and continue with >>.
3. Select the gateway control module and continue with >>.
4. Select coding and continue with >>.
5. Select the respective equipment versions and code them.
6. Follow the instructions on the PIWIS tester.
7. Read out the fault memory and, if necessary, erase it.
Subsequent work
Install cover under dashboard on the passenger's side.
