porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Seat Occupant Classification Module - Air Bag|Testing and Inspection|Page 6930 > < Seat Occupant Classification Module - Air Bag|Testing and Inspection|Page 6928
Page 1
background image

Seat Occupant Classification Module - Air Bag: Adjustments

Calibrating AWS Control Unit

Tools

Calibrating AWS control unit

NOTE:  Follow the instructions on the Tester.

Later versions of the software may display slightly different text or require a slightly different procedure. The instructions you receive from the tester
itself take precedence over this description.

NOTE:  Calibration applies to vehicles as of MY '06 with country equipment (USA, Canada, Mexico).

DANGER:

Incorrect information for AWS control module.

-

Passenger's airbag is triggered differently.

-

If the passenger's seat was removed and re-installed, the AWS control module must be calibrated.

-

If the seat bracket was replaced, the AWS control module must be calibrated.

-

If the AWS control module was replaced, the AWS control module must be calibrated.

WARNING:
Sudden voltage interruption of the power supply to the control module.

-

Destruction of the control module.

-

During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery
charger with a current rating of at least 40 A to the vehicle battery.

-

Prior to disconnecting the control module, switch off the ignition and remove the ignition key.

1. Connect battery charger to the vehicle. Move passenger's seat longitudinally until flush with the seat rails and to its lowest position.
2. Connect the Porsche System Tester PIWIS Tester 9718 to the vehicle and start the System Tester. Switch on ignition. Press .>>" to continue.
3. Select vehicle type.
4. Switch from the vehicle type to the list of control units by pressing .>>".
5. Select AWS control unit and press the .>>" key.
6. Select the Calibration menu. Press .>>".
7. The Tester displays several messages and instructions relating to the individual work steps until the message Test step was completed successfully

appears. Press .>>".

NOTE:
A system test can only be performed successfully if:
-

The AWS control unit has been taught on the airbag control unit.

-

There are no faults in the AWS and airbag control unit.

8. Select the System test menu in the AWS control unit.

Seat Occupant Classification Module - Air Bag|Testing and Inspection|Page 6930 > < Seat Occupant Classification Module - Air Bag|Testing and Inspection|Page 6928