Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1516011.png)
2. Twist seat-belt buckle -arrow B- and pull it out of the belt guide -arrow C-.
3. Position belt reel between the two guide lugs -arrow- and screw down with the fastening screw -5-. - Tightening torque: 37 ft lb.
4. Install padding for rear backrest.
5. Install headrests.
6. Install backrest.
7. Perform a function test.
-
The belt strap must be fully rolled up when the function test is started.
-
Move the seat belt height adjustment to the highest position.
-
Pull out belt strap completely as far as it will go.
-
Roll up the belt strap again slowly. An audible clattering noise can be heard when you do this.
-
If the rolling-up process is interrupted, the belt strap cannot be pulled out again (permanent belt blockage).
-
The permanent belt blockage feature must be disabled at least 100 mm before the belt strap is completely rolled up in order to ensure that the
belt strap can be pulled out again.
-
The belt strap use be able to run freely in all directions.
