porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Removing and Installing Cut-Off Relay|Page 5390 > < Removing and Installing Cut-Off Relay|Page 5388
Page 2
background image

2. Disengage front trim panel at the rear -arrow A-, then unclip it by pulling it forward -arrow B-.

3. Unclip the right and left carpet cover -arrows-.

4. Unscrew the two fastening screws -1-.
5. Fold the seat back as far as possible -arrow A-. With the seat in its folded position, move the seat forward again using the fore/aft adjustment

-arrow B-.

6. Fold carpeted floor forwards -arrow A-. Unscrew fastening nut -1- from the battery ground strap on the body and remove the ground strap from the

stud -arrow B-.

7. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is avoided.

Removing and Installing Cut-Off Relay|Page 5390 > < Removing and Installing Cut-Off Relay|Page 5388