Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1339004.png)
Information:
For vehicles with PDCC, raise the wheel suspension slightly using a transmission jack (do not raise wheel suspension higher than normal vehicle
position (vehicle resting on wheels). This changes the angular position of the control arm and the spring strut can be removed by turning carefully.
9. Carefully remove spring strut downwards -arrow-.
Installing rear spring strut
Caution:
Increased risk of accident due to raising the wheel carrier incorrectly. When filling the air spring struts, the vehicle lifts.
^
Injury and material damage possible.
-> Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a suitable
intermediate layer (hard rubber).
-> Do not damage the brake cover plate.
Information:
^
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a suitable
intermediate layer (hard rubber).
^
Do not damage the brake cover plate.
^
The entire threaded parts of the axle must be tightened in vehicle position! Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised with a universal vehicle lift! Dimension -X-, from lower edge of wing to middle of axle 506 mm, ±10 mm corresponds
to vehicle position!
^
Carry out a visual inspection of all parts!
^
Replace self-locking nuts!
^
If a new spring strut is fitted, it must be pre-filled to 3 bar in its original packaging.
^
Replace all expansion screws (screws which are fitted with torque angle tightening procedure)!
^
Use correct tightening torques and torque angle!
