Cayenne Titanium (9PA) V8-4.5L (2006)
Removing rear wheel bearing
Component overview of wheel bearing
Component overview of wheel bearing
-1- -
Wheel bearing housing (Carry out a close visual inspection of the seat of the wheel bearing. There must be no scores, grooves or similar
deformations.)
-2- -
Wheel bearing (The wheel bearing can no longer be used once it is removed. Use a new wheel bearing. Do not press on the inner race. Insert
the wheel bearing with the magnetic multiple-pole ring towards the drive shaft. Check the magnetic side (e.g., with a paper clip). Do not use
magnets or screw drivers for the check!
-3- -
Circlip (Use new circlip.)
-4- -
Wheel hub (Pull inner race off separately from the wheel bearing. Carry out a close visual inspection of the seat of the wheel hub. There must
be no scores, grooves or similar deformations on the hub.)
-5- -
Axle nut (Lock nut - always replace. Grease contact surface with a little Optimoly TA. Use the specified tightening torque.)
1. Release brake caliper and hang at a suitable place in the wheel housing.
2. Remove brake disc.
3. Disengage the cable of the foot-operated parking brake and remove the brake shoes.
4. Remove wheel speed sensor -see illustration-.