Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
2. Screw in fastening screws -2- and tighten so that camera -1- can still be moved.
3. Adjust seam joining line.
3.1. Adjust seam joining line at the side -I-. - Gap dimension: 3 mm
3.2. Adjust seam joining line to moulding -H-. - Gap dimension: 2mm±0.8mm
4. Tightening fastening screws -2- to the specified tightening torque. - Tightening torque: 1.2 Nm (1.0 ftlb.)
5. Route and fasten wire harness.
5.1. Position wire harness on velcro fastening and press it on -arrow-.
5.2. Secure wire harness on retaining clip using a tie-wrap.
Subsequent work
1. Install rear lid trim panel.
2. Perform a function test.
2.1. Extend reversing camera using the PCM. Check whether the camera is fully extended and whether the images are transmitting correctly.
2.2. Retract reversing camera using the PCM. Check whether the camera is fully retracted.