Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
-
To prevent oil from spreading into the body front section, a material 00000 should be held underneath.
8. Hold shop-made tool (material) 00000 -Figure- under the ATF thermostat.
Discharge chute
9. Disconnect ATF lines from thermostat and drain ATF.
10. Remove thermostat.
Installing ATF thermostat
Overview of ATF cooler
Information
-
The sealing rings at the ends of the ATF lines on the transmission and cooler sides must be replaced before installation.
1. Replace sealing rings on the ATF lines and coat with ATF.
2. Connect transmission-side ATF lines to thermostat. Insert the upper line first.
3. Insert ATF cooler lines.
4. Tighten ATF thermostat fastening screw -Arrow- to cooler. - Tightening torque: 3.5 Nm (2.5 ftlb.)