Cayenne Turbo S (9PA) V8-4.5L Turbo (2006)
/v8-4.5l_turbo/Page-271005.png)
Installing airbag sensor
Installing sensor on lock support
WARNING: Danger of injury caused by loose, safety-related bolts.
-
Always replace fastening screws of the sensors after customer service and reworking.
-
Never make alterations to the micro-encapsulated screws, which have a negative effect on the bond (e.g. using lubricant, loosening bolts
and screwing them down again).
INFORMATION:
-
6 sensors are used for the airbags in the Cayenne.
-
The front two sensors are located on the lock support.
-
The middle two sensors are located on the floorpan behind the front seats.
-
The rear two sensors are located on the rear wheel housings.
INFORMATION: If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will be
supplied with a barcode sticker (tear-off label).
-
Tear off the tear-off label -2- on the new component -1- and stick it under the heading Proof of airbag system check/component replacement in the
Guarantee and Maintenance booklet.
-
The replacement date and mileage must be documented and the booklet must be stamped with the dealer's stamp.
INFORMATION: Make sure that the sensor is properly positioned.
