Cayenne Turbo S (9PA) V8-4.5L Turbo (2006)
/v8-4.5l_turbo/Page-1378006.png)
^
During installation, insert new sealing rings -arrow- on the steering gear. Take care not to damage the sealing ring when fitting the joint boot.
^
Carry out a close visual inspection of all parts.
^
When fitting the ball joints, ensure that the bevel pinions are clean! Remove dirt or grease on bevel pinions, e.g. with a lint-free cloth. Do not use
cleaning agent/solvent.
^
Observe correct tightening torques.
^
Calibrate steering angle sensor.
Ensure that no damage (scoring or similar damage) is caused to the steering rack.
Fit joint boot (not twisted) and secure with new clamps -see figure-.
The arrow denotes the clamp lug.
When fitting the large clamps, it is essential to observe the following installation position (right/left). The clamps must be fitted in the correct position.
Place the pliers for lug hose clamp NR.74 on the clamping washer lug and lightly clamp. It should still be possible to easily turn the clamps. Check the
position of the clamp once more, correcting if necessary, and then compress the clamp lug fully.
