Cayman S (987) F6-3.4L (2008)
/f6-3.4l/Page-575012.png)
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
4. Pull the line and the rubber sleeve out of the passage to the plenum panel over the wheel housing.
Installing the condenser-fluid tank line
1. Push line into the plenum panel via the wheel housing and press rubber sleeve into place. Ensure that rubber sleeve is fitted correctly.
INFORMATION: When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
2. Clip line into the line holder at the top, insert line into the condenser and screw down with -2- fastening screw. Tightening torque: 14 Nm (10.5
ftlb.)
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
3. Push together line in plenum panel and screw on with the -1- fastening screws. Tightening torque: 20 Nm (15 ftlb.)
Subsequent work
