18I/Sportwagon L4-2165cc 2.2L (1985)
Instrument Cluster / Carrier: Service and Repair
Fig. 6 Instrument cluster removal.
Custom Models
1.
Disconnect battery ground cable and remove steering wheel.
2.
Remove both lower steering column covers, then remove two panel to dash attaching screws, Fig. 6.
3.
Disconnect speedometer cable and instrument panel electrical connectors.
4.
Tilt instrument panel forward, then using screwdriver, pry upper part of instrument panel outward while pressing lower part inward and remove
instrument panel from vehicle.
5.
Reverse procedure to install. Tilt instrument panel forward until it can be attached to pins located in instrument cluster opening.
Fig. 7 Instrument cluster removal.
Deluxe Models
1.
Disconnect battery ground cable, then remove instrument panel covers (1), Fig. 7.
2.
Remove screws (A), then remove bezel (3) from switch panel (4).
3.
Disconnect electrical connectors from switches, then remove switch panel (4).
4.
Press instrument cluster retaining clips toward center of cluster and pull cluster slightly forward. Disconnect speedometer cable and instrument
panel electrical connectors, then remove instrument panel.
5.
Reverse procedure to install.
The lighting, turn signal and wiper switching functions are included in a combination switch. On these models, refer to ``Light Switch, Replace'' for
replacement of front wiper switch.
