Alliance/Encore L4-1721cc 105 CID (1985)
4.
Remove the clamp and short heater hose from the tee going to the radiator (Fig. 21). Install the supplied short hose on the tee with the supplied
clamp. Torque the clamp to 10 in. lbs. (1 N-m).
5.
Fill the heater core with coolant and install both hoses on the quick-connects as described in Section I.G.8. and continue with the procedure to
reassemble interior components of the vehicle.
III. Special Replacement Instructions For 1987 Models
Installation of Heater Core Quick-Connects and Hoses
1.
Install the 90 degree quick-connect on the bottom heater core nipple (inlet) and the straight quick connect on the top nipple (outlet) of the heater
core.
2.
Install the supplied rubber bulkhead seal and retainer plate over the quick-connects with the supplied screws.
